DE-STA-CO F5-B AC Inverter Drive - Manual (Page 44)

44
Adjustment of the Drive
The positioning function enables the approach of a position with a signal
from different frequencies. With parameter CP.27 the stop position can
be adjusted, which entails an additional constant running time. CP. 27
selects positioning on/off and if positioning is on and additional run time.
This additional run time is added to every speed. In the example below
CP.27 is set to 0.00. This selects posiitioning without a positioning delay. Positioning Delay
Factory setting CP.22: 27
Note: Enter-Parameter
Relay output 2
Switching level
This parameter determines the switching point for relay output 2. Since the
operator display can only view 5 characters, the last digits are not
displayed for the higher values. Note; all conditions chosen with CP.22
don't require use of CP.23.
Adjustment range: -30000.00...30000.00
Resolution:
0.01
Factory setting: 0.00
Start
(pin 14)
Stop
(pin 11)
Stop From
Max Speed
Speed 1
(MAX)
Speed 2
Stop From
Low Speed -
No Positioning
Speed 1
(MAX)
Speed 2
Stop From
Low Speed -
Positioning
Speed 1
(MAX)
Speed 2
0 Hz
0 Hz
0 Hz
Additional run
time so that the
stop point is the
same as the
stop from the
max speed.