Climax LM5000 OBS Portable MILL - Manual (Page 5)

05/99 5
PM5000 Specifications
(A) MAIN BED:
Height (w/saddle) 4.96 (126.0)
Width 12.0 (304.8)
Length (varies) 58.0 (1473.2)
82.0 (2082.8)
106.0 (2692.4)
MAIN BED SADDLE:
Mounting face 8 x 8 (203.2 x 203.2)
Travel (varies) 48 (1219.2)
72 (1828.8)
96 (2438.4)
(B) RAM & CROSS SLIDE:
Height (w/saddle) 7.62 (193.5)
Width (w/saddle) 8.92 (226.6)
Length 22.0 (558.8)
Cross slide mounting face 6 x 6 (152.4 x 152.4)
Cross slide travel** 7.63 - 14.0 (193.8 - 355.6)
** Machining area varies by application.
Indexable in 90°, offset in 3.38" (85.85) increments.
(C) VERTICAL SLIDE:
Height 2.0 (50.8)
Width 6.0 (152.4)
Length 12.0 (304.8)
Mounting face 6 x 6 (152.4x152.4)
Travel 6.0 (152.4)
(D) FEED ASSEMBLIES:
Feed assemblies are required for both X and Y
axis.
MANUAL FEED:
.20"/rev (5.08 mm/rev)
STANDARD ELECTRIC FEED, 115v:
Manual feed (handwheel) .10"/rev (2.54 mm/rev)
Electric feed 0-10"/min (0-254 mm/min)
HEAVY-DUTY ELECTRIC FEED, 115v:
Manual feed (handwheel) .10"/rev (2.54 mm/rev)
Electric feed 0-24"/min (0-609.6 mm/min)
(F) MILLING HEAD ASSEMBLY:
SPINDLE:
Quill diameter 3 (76.2)
Tool sizes available #40 taper
QUILL CLAMP:
Indexable, 90 0 increments.
MILLING HEAD GEAR BOX:
Drive ratio (belt drive) 1:1
Hydraulic rpm varies by motor selected (see pg. 13)
Milling head gear box can be rotated around
spindle centerline 180 0 .
Inch (mm) For precise dimensions consult your factory representative.
PM5000 milling area (dimensions to the centerline of the
spindle). Total work surface available by offsetting and
rotating the ram and milling head, When milling overhead,
entire area can be milled by offsetting the ram.
27.44
(697.0)
10.0 (254.0) + bed length
7.63
(193.8)
3.8 max
(96.5)
7.63
(193.8)
max
27.44
(697.0) max
shown with ram offset