Climax LM5000 OBS Portable MILL - Manual (Page 8)

8 05/99
PM5000 Orientation Options
Inches (mm)
GEAR BOX POSITIONS
The lightweight aluminum gear box can be rotated
around the spindle centerline 180 o to clear obstructions.
MULTIPLE RAM POSITIONS
The cross slide ram can be repositioned and indexed in
90 o increments for maximum versatility. For maximum
accuracy, re-tram the milling head and reset after
repositioning any components.
MILLING HEAD POSITIONS
Because the quill clamp is symmetrical, the milling
head can be indexed in 90 o increments around the
vertical slide on the ram. This allows the milling head to
machine down, overhead, or to the side. The milling
head can also be offset to increase tool reach. For
maximum accuracy, re-tram and reset the milling head
after repositioning any components.
3.84 (97.5)
Minimum "A" With handwheel -D- Without handwheel -D-
Required to clear -B-
17.8 (452.2) w/o riser 15.6 (396.3) w/o riser
Required to clear -C-
20.8 (528.4) with 3 (76.2) riser 17.8 (452.2) w/o riser
ram extended
to the right
ram extended
to the left
positionable in
3.38 (85.85)
increments
index in 90 o
increments
A
C
B
D
13.50 (342.9) max
12.6 (320.0) max / 6.6 (167.6) min
Vertical slide in center position
with no risers. Can be offset
2.13 (54.1) in two directions.
10.88
(276.35)
19.95 (506.7) max
(without risers)
quill
0.85 (21.6) without risers
and with vertical slide
mounted in lowest position
18.0
(457.2)