Zv u – CEMB USA SM900 User Manual

Page 30

Advertising
background image

30

Z

V

U

Fig. 11 - Abb. 11

Fig. 12 - Abb. 12

•Lubricate the tyre beads with the special grease in order to avoid damaging them and to facilitate the mounting operations.

Never place your hands between the wheel rim and the clamps during the locking stage or you will risk
crushing them.

Note: When you are working with rims of the same size, it is not necessary always to lock and unlock the mounting bar; just
move the horizontal arm (N) sideways with the mounting arm (M) locked.

•Move the tyre so that the bead passes below the front section of the mounting head and is brought up against the edge of the
rear section of the mounting head itself.

•Keeping the tyre bead pressed down into the wheel rim channel with your hands, press down on the pedal (Z) to rotate the
turntable clockwise. Continue until you have covered the entire circumference of the wheel rim (Fig. 12).

•Insert the inner tube (if there is one).

•Repeat the same operations to mount the upper side of the tyre.

Do not place your hands on the wheel: when moving the arm to its working position your hand could
be crushed between the rim and the mounting head.

To prevent industrial accidents, keep hands and other parts of the body as far as possible from the
tool arm when the table top is turning.

NOTE: Demounting and mounting are always done with the clockwise turntable rotation. Anticlockwise rotation is
used only to correct operator's errors or if the turntable stalls.

6.4 MOUNTING THE TYRE

WARNING: This checking of tyre and rim is of th utmost importance to prevent tyre explosion during the
inflating operations. Before beginning mounting operation make sure that:

- the tyre and the cord fabric are not damaged. If you note defects DO NOT mount the tyre.

- The rim is without dents and is not warped. Attention with alloy rims, dents cause internal micro-cracks not
visible to naked eye. This can compromise the rim and can also be a source of danger especially during

inflation.

- The diameter of the rim and tyre are exactly the same. NEVER try to mount a tyre on a rim if you cannot
identify the diameters of both.

Advertising