DE DIETRICH NEO 2.1 - Manual (Page 11)

4 Installation
4.1 Regulations governing installation
CAUTION
The installation must be equipped with a protective plastic
film (roof underlay film).
CAUTION
4
The installation must comply in all matters to the
standards and rules which govern the work and
interventions in individual and collective homes, and
other constructions.
4
The installation and maintenance of the appliance
must be carried out by a qualified professional in
compliance with the statutory texts of the codes of
conduct in force.
4
Before installation, make sure that the framework is
solid and strong enough to comply with the static
requirements.
4
Solar installations must be earthed to protect them
against lightning.
4
Protection of the environment: Place a container of
sufficient volume under the drain pipe and the valve
discharge pipe.
4
The roof mounting pack makes it possible to install
the solar collectors on roofs with structures
presenting a minimum incline of 17°.
4
The roof-integral installation set is designed specifically as a
mounting system for the NEO 2.1 flat solar panels and may only
be used in accordance with their building regulations approval.
4
The mounting kit is designed for roof coverings in standard
mechanical roman roof tiles for the South of France.
4
The water drainage channels on the membrane should run into
the eaves (roof gutter).
4
The installation should therefore not be flushed or filled when the
collectors are hot (in strong sunshine).
4
The solar system must at all times be filled with heat transporting
fluid.
M001788-A
M002132-A
NEO 2.1 / SUN 211 4. Installation
20/02/2013 - 300024195-001-02 10