Burkert Type 2101 - Manual (Page 15)

15
Removal
Type 2101
Warning!
seat leaks caused by the minimum pilot pressure being too
low (on cfb and cfi) or the medium pressure being too high!
• Observe the minimum control pressure and medium pressure
(see “6.4.2”).
9. mainTenance Work
→
Complete a visual inspection of the equipment once a year. Shorter
maintenance intervals may be recommended depending on the
operating conditions.
9.1. replacement parts
Caution!
risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable replacement parts may
cause injuries and damage the device and the surrounding area.
• Use only original accessories and original replacement parts
from Bürkert.
wearing parts: Seals and the swivel plate.
→
In the event of a leak, replace the relevant wear part.
The maintenance and repair instructions are available on the
Internet:
www.burkert.com
10. removal
Danger!
risk of injury from discharge of medium and pressure!
It is dangerous to remove a device which is under pressure due to
the sudden release of pressure or discharge of medium.
• Before removing a device, switch off the pressure and vent the lines.
procedure:
→
Loosen the pneumatic connection.
→
Remove the device.
11. PackaGinG, TransPorT,
sToraGe
note!
transport and storage damage!
• Protect the device against moisture and dirt in shock-resistant
packaging during transportation and storage.
• Permitted storage temperature: -20 – +65°C.
damage to the environment caused by device components
contaminated with media.
• Ensure the device and packaging are disposed of in an environ-
mentally sound manner.
• Observe applicable regulations on disposal and the
environment.
english