Burkert Type 8186 - Manual (Page 26)

l All data of the menu "Setup" and "Display"
l In the menu "Additional settings" the items "Distance unit,
temperature unit and linearization"
l The values of the user programmable linearisation curve
The copied data are permanently saved in an EEPROM memory in the
indicating and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sensors
or kept as backup for a possible sensor exchange.
Kind and volume of the copied data depend on the respective sensor.
Note:
Before the data are stored in the sensor, a check is carried out to
determine if the data fit the sensor. If the data do not fit, a fault signal is
triggered or the function is blocked. When data are being written into
the sensor, the display shows which instrument type the data originate
from and which TAG-no. this sensor had.
In this menu, you read out the instrument name and the instrument
serial number:
In this menu item, the hardware and software version of the sensor is
displayed.
In this menu item, the date of factory calibration of the sensor as well
as the date of the last change of sensor parameters are displayed via
the indicating and adjustment module or via the PC.
Info/Instrument name
Inf/Instrument version
Info/Calibration date
26 Indicating and adjustment module
6 Setup - sensors from software 4.0.0
41787
-EN
-120316