Hydrotech Precision-PWS 8-M_8-MST OWNERS GUIDE - Manual (Page 22)

1. Remove any protective plastic coating (white, blue or clear plastic) from
the lid.
Boiling Tank Lid Installation
Boiling Tank Lid Operation Diagram
2. Refer to the Boiling Tank Lid Operation Diagram above. Take the
boiling tank lid in your hand. Hold the Tee Bar bracket and turn the Lid
Knob counter-clockwise so that there is ½” of space between the Tee Bar
bracket and the lid.
3. Tip the lid so that the Tee Bar bracket slips under the rim of the boiling
tank opening on one side, and then slide the lid so the Tee Bar bracket
slips under the other side of the rim. Center the lid.
4. Turn clockwise to tighten the lid onto the boiling tank. The water level pin
inside the boiling tank will prevent the lid from turning while tightening.
Practise removing and replacing the lid a few times as the lid will need to
be removed each time the water distiller is filled or cleaned.
Optional Storage Tank Lid Removal and
Installation
1. To remove the optional storage tank lid, turn the Lid Knob counter-
clockwise while lifting. Lifting while turning holds the Tee Bar bracket
under the lid and allows you to loosen the lid. Continue turning and lifting
until there is ½” of space between the Tee Bar bracket and the lid.
2. Tip the lid so that the Tee Bar bracket slips out from under the rim of the
optional storage tank opening on one side, and then slide the lid so the
Tee Bar bracket slips out from under the other side of the rim.
3. To Replace the optional storage tank lid, tip the lid so that the Tee Bar
bracket slips under the rim of the boiling tank opening on one side, and
then slide the lid so the Tee Bar bracket slips under the other side of the
rim. Center the lid.
4. While lifting up on the optional storage tank lid knob, turn clockwise to
tighten the lid onto the optional storage tank. When upward pressure is
no longer needed to prevent the lid from turning the lid is tight.
22