Hydrotech Precision-PWS 8-M_8-MST OWNERS GUIDE User Manual
Page 34
distiller continues to heat up, it will sterilize the water distiller with steam
by allowing pure steam to travel out of the cooling coil. Water and steam
will drip from the sterilization tube. Caution: The Water Distiller is
extremely hot during sterilization.
7.
Leave the water distiller on for 1 hour.
8.
After the sterilization cycle is complete, turn the fan switch ON and allow
any water in the cooling coil to drain. Leave the water distiller running
with the fan on for about 15 minutes.
9.
The water distiller will be very hot so turn all switches OFF (power and
fan) and let the water distiller cool down for approximately 1 hour.
10.
Remove the sterilization drip tube by pulling the plastic tube off the
stainless steel charcoal filter inlet tube (keep the sterilization tube for
future sterilizations).
11.
Replace the charcoal in the post charcoal filter canister. See Replacing
Charcoal in Post Charcoal Filter Canister (Used with 8-M without
Optional Storage Tank) in this Maintenance and Cleaning Section.
12.
The water distiller head is sterilized and ready for operation.
34