Hydrotech Precision-PWS 8-M_8-MST OWNERS GUIDE - Manual (Page 33)

Steam Sterilization of Water Distiller Head
1. Make sure the water distiller is cool before starting.
BULKHEAD,3/8"
(INSIDE DISTILLER)
STERILIZATION TUBE
3/8OD X 1-1/2"
SS TUBE
JG TUBE REMOVAL DISK
PART # 500282
BULKHEAD,3/8"JG
Steam Sterilization Diagram
2. Refer to the Steam Sterilization Diagram above. If you are using the
optional storage tank, lift the front corner of the water distiller head and
remove the charcoal filter.
3. Install the sterilization tube. Place the sterilization tube on the 3/8”
stainless steel filter inlet tube on the bottom of the water distiller head.
4. Place the other end of the steam sterilization tube into a container as it will
drip water and steam.
5. Fill the boiling tank with water to the bottom of the water gauge pin.
Steam Sterilization Operation Switches Diagram
6. Refer to Steam Sterilization Operation Switches Diagram above. Turn
only the power switch ON. Leave the fan switch OFF. As the water
33