Clear-Com Production-Maestro-Pro - Manual (Page 48)

change is sent to the matrix.
Remove cursor [dynamic]
meter Except in Administrator mode, the user does not have
access to the dynamic / cursor audio levels meter, located
to the right of the canvas screen
(see 4.20.7 Dynamic meter).
This restriction may be imposed to prevent the unnecessary
usage of system resources.
Table 11: User restrictions
4.20 Using audio level meters (Clear-Vu ®)
You can apply Clear-Vu ® audio level meters [ ] to conferences and four-wire ports in real-time
with Production Maestro Pro. The meter setups can be saved to the project (layout) file (*.ccr). Audio
level meters can be added to four-wire ports in the palette in a reduced format.
This facility normally requires at least one LMC-64 audio metering card to be fitted to the matrix.
Tip: You can set up a single audio meter without an LMC-64 card in Settings > Associated Meter
Port. For more information, see 4.19.2 Setting up an Associated Meter Port.
You can configure the number of audio meters provided by an LMC-64 card to 16, 32, 48 or 64
meters in EHX. The same audio meter data can be used by multiple Production Maestro Pro clients,
which means that multiple assignments of the same audio meter will not use up additional meters.
The total number of available meters:
• Is displayed in Production Maestro Pro within the
red circle of the meter icon (for
example, , or ).
• Updated on all Production Maestro Pro clients, every time a meter is applied.
You can still assign meters to a four-wire or conference when zero free meters [ ] are reported,
provided that the four-wire or conference:
• Already has a meter assigned to it.
• The audio level data is already being broadcast.
In this case a new meter does not need to be assigned to the target.
48 Eclipse Production Maestro Pro User Guide