Clear-Com Production-Maestro-Pro - Manual (Page 53)

4.20.6 Removing a meter from a conference
To remove a meter from a conference:
1. Go to Configure Canvas.
2. Drag the attached audio meter away from the conference and drop it on the canvas.
4.20.7 Dynamic meter
The dynamic meter (also referred to as the cursor meter) is used to dynamically meter audio levels
while in Assignment mode.
Note:
Unlike the fixed four-wire meters (see 4.20.3 Adding a meter to a fixed four-wire on the canvas)
the dynamic meter allows metering of four-wires placed in a Port Viewer.
To access and use the meter:
1. In Assignment mode, reveal the meter by clicking the meter toggle bar [ ] to the right of
the canvas screen.
2. Click the meter icon [ ] to attach the meter to the mousepoint. The meter icon follows the
mousepoint, wherever it is moved on the screen [ ].
3. Move the meter [ ] over the item (the conference, four-wire or Port Viewer)
on the canvas or palette you want to meter:
• To meter the input of a four-wire on either the palette or canvas, move the meter
over the left-hand side of the four-wire.
• To meter the output of a four-wire on either the palette or canvas, move the meter
over the right-hand side of the four-wire.
• To meter the input of a four-wire placed in a Port Viewer on the canvas, move the
meter over the left-hand side of the four-wire.
• To meter the output of a four-wire placed in a Port Viewer on the canvas, move the
meter over the right-hand side of the four-wire.
• To meter a conference on the canvas, move the meter over the conference.
After a short delay (500ms), the heading above the large meter on the right of the screen
changes to match the point you want to meter, and metering begins.
The audio level is displayed on the scale to the right of the canvas screen [ ].
53 Eclipse Production Maestro Pro User Guide