Hach-Lange AMTAX inter2 Basic User Manual - Manual (Page 100)

English 100
Figure 4 Hose connections Electrical connections
Change of the fuse
Hose connections with
SEDITAX 2
Hose connections with
FILTRAX
One-channel operation
Hose connections with
FILTRAX
Two-channel operation
1 Drain 1 Sample feed 1 Sample feed 1
2 Sample feed via
Teflon sample pipe
from
SEDITAX 2 2 Sample overflow 2 Sample overflow 1
3 Drain 3 Drain
4 Sample feed 2
5 Sample overflow 2
SEDITAX 2 FILTRAX - 1 FILTRAX - 2
N O T I C E
Only shielded lines may be connected!
D A N G E R
Some circuits in this device are protected by fuses against overvoltages. For
constant protection against risk of fire, replace these fuses only with fuses of the
same type and power rating.
D A N G E R
Defective fuses generally indicate a problem in the device. If fuse errors
repeatedly occur, contact the service department for instructions on the return
procedure for repair purposes. Under no circumstances attempt to repair the
device independently.
N O T I C E
On removal of the power plug (fixed installation of mains supply lead), a suitable
bipolar circuit breaker must be installed!
N O T I C E
Pull out the power plug before opening the device.
N O T I C E
All connected signal connection lines must be shielded