Hach-Lange SC 100 - Manual (Page 11)

Installation
7
Section 3 Installation
DANGER
Only qualified personnel should conduct the installation tasks described in this section of
the manual.
DANGER
Do not replace any component unless power has been switched off or the area is known to
be non-hazardous.
Figure 1 Components of a Basic System
1. Controller 6. Lock washer, ¼-inch I.D. (4), Cat. No. 8H1336
2. Mounting foot for panel mounting (2), Cat. No. 1000B4F3222 7. Flat washer, ¼-inch I.D. (4), Cat. No. 8H1346
3. Bracket for panel & pipe mounting,
Cat. No. 1000C4F3217-101 8. Pan head screws (4), M6 x 1,0 x 20 mm,
Cat. No. 5867400
4. Gasket for panel mounting, Neoprene,
Cat. No. 1000A4F3249-101 9. Pan head screws (4), M6 x 1,0 x 100 mm,
Cat. No. 5867500
5. Hex nut, M6 (4), Cat. No. 5867300 10. Pan head screws (4), M6 x 1,0 x 150 mm,
Cat. No. 5867600
Table 1 Customer-supplied Items
Item
14-AWG wire for electrical power connections in conduit or 115 or 230 V ac power cord plus a IP65 / NEMA 4X-rated strain
relief
High-quality, shielded instrumentation cable for connecting the analog outputs plus a IP65 / NEMA 4X-rated strain relief.
Mounting hardware for the sensor (available from the manufacturer, order separately). See the sensor manual.
Sun shield for mounting configurations where the sun strikes the front of the display.
Common hand tools
1
3
4
8
5
6
7
9
10
2
sc100