Hach-Lange SC 100 - Manual (Page 30)

Controller Display Features
26
Operation
4.2 Controller Display Features
When a sensor is connected and the controller is in measurement mode, the controller
automatically identifies the connected sensors and displays associated measurements.
The display will flash on startup, when a sensor error has occurred, when the hold outputs function
has been activated, and when a sensor is being calibrated. An active system warning will cause
the warning icon (a triangle with an exclamation point inside) to be displayed on the right side of
the display. See
Figure 23 .
Figure 23 Display Example
4.2.1 Important Key Presses
• Press HOME then RIGHT or LEFT to display two readings when two sensors are connected.
Continue to press RIGHT or LEFT to toggle through the available display options:
• Press UP and DOWN to toggle the status bar at the bottom of the measurement display to
display the secondary measurement (temperature) and output information.
• When in Menu mode, an arrow may appear on the right side of the display to indicate that
more menus are available. Press
UP or DOWN (corresponding to the arrow direction) to
display additional menus.
1. Status bar. Indicates the sensor name and status of relays. The relay
letter is displayed when the relay is energized. 4. Parameter
2. Main measurement 5. Warning icon area
3. Secondary measurement (if applicable) 6. Measurement units
7.00
SENSOR NAME:
pH
TEMP: 23.0°C
1
2
3
6
5
4
pH pH pH
7.00
SENSOR NAME:
TEMP: 23.0°C
7.00
SENSOR NAME:
OUTPUT1: 12.00 mA
pH
7.00
SENSOR NAME:
OUTPUT2: 12.00 mV
pH pH
SENSOR DIAG
SENSOR SETUP
TEST/MAINT
MAIN MENU
SYSTEM SETUP
OUTPUT SETUP
SYSTEM SETUP
NETWORK SETUP
RELAY SETUP
DISPLAY SETUP
DISPLAY SETUP
SYSTEM SETUP
LOG SETUP
SECURITY SETUP
CALCULATION
SECURITY SETUP
SYSTEM SETUP
CALCULATION
LOG SETUP
ERROR HOLD MODE