Hach-Lange NH4D sc Ammonium Sensor - Manual (Page 21)

21
Operation
CAL.CONFIG.>
FACTORY CAL
Selection of the preset sensor code
DATE Date of last calibration
SENSOR CODE Enter the sensor code
CONFIGURE
EDIT NAME Entry or editing of the name. Up to 10 alphanumeric characters.
MEAS UNITS Selection of mg/L or ppm as measurement unit
SET PARAMETER Selection of NH
4
–N or NH
4
TEMP UNITS Selection of °C or °F as temperature unit.
TEMP CORR Entry of the temperature correction (–1.5 to +1.5 °C or –2.7 to +2.7 °F)
RESPONSE TIME Entry of the response time (30 sec to 300 sec)
LOG SETUP
Selects the interval for the data logging
(deactivate, 1, 2, 5, 10, 15, 30 min, 1, 2, 6 hr).
K+ COMPENSATE. Selection of the potassium compensation: On or off
SET DEFAULTS Resets the configuration on the factory setting.
DIAG/TEST
PROBE INFO
Information on the connected sensor
EDIT NAME Name of the connected sensor
SERIAL NUMBER Serial number of the connected sensor
SOFTWARE VERS Software version
CAL DATA Data of the selected MATRIX correction
SIGNALS
Signals and measurements of the individual measurement channels
AMMONIUM Displays the signals and measurement results
POTASSIUM Displays the signals and measurement results
TEMP Displays the temperature
COUNTERS
Sensor code (time the sensor code was entered generally corresponds with the age of the
cartridge) and CAL. days
SERVICE Performing a sensor check using TEST CARTRIDGE (see 7.2 on page 37 )
4.5 Sensor setup menu (continued)