Hach-Lange DR 3900 Basic User Manual - Manual (Page 115)

English 115
1. Plug the USB storage device into the USB type A port on the
DR 3900, or connect the DR 3900 to a network drive.
2. Press Recall Data from the Main Menu.
3. Select the data category to be transferred, e.g. Data Log.
A list of the selected measurement data is displayed.
4. Press Options and then the PC & Printer icon.
5. Select the data to be sent.
The following options are available:
•
Single point: only this selected reading will be sent
• Filtered data: only readings that correspond to the set filters
will be sent
• All data: all data in the selected data category will be sent.
6. Press OK to confirm.
Note: The number in parentheses is the total number of data sets
assigned to this selection.