3 1-channel open-loop control – Hach-Lange WTOS P-RTC User Manual
Page 19
19
Parameterization and operation
4.3.3
1-channel open-loop control
1-channel open-loop control
CONFIGURE
SELECT SENSOR
Select the sensor installed for the open-loop control (see
OPEN-LOOP
PRECIP. TYPE
Precipitation, simultaneous precipitation, post-precipitation
SETPOINT PO4-P
Desired orthophosphate value in effluent (refer to
)
[mg/L]
CORR FACTOR
Percentage correction of precipitant dosing (see
[%]
BIO-P
Phosphate biologically eliminated after influent (refer to
[%]
MIN DOS RATE
Minimum flow rate of dosing pump
[L/h]
PRESELECT PROG
Programs 1 to 4 (refer to
)
PROFILE
Active
when a measurement signal fails
Q-PROFILE
Daily profiles (2 h average) of waste water influent according to feed measurement
signal
[m³/h]
P-PROFILE
Daily profiles for PO
4
-P concentrations, 2 h average (see
)
[mg/L]
WEEK PROFILE
Percentage daily averages of the phosphate load (refer to
(volume × concentration)
[%]
IN- OUTPUTS
DOSING PUMP
MIN PUMP RANGE
Lower threshold of flow rate range
[L/h]
MAX PUMP RANGE
Upper threshold of flow rate range
[L/h]
0/4...20MA
Selection of transfer range according to pump input
CONTROL CYCLE
Control cycle comprising on- and off-time (see
)
[s]
MIN RUNTIME
Minimum on-time of pump (refer to
)
[s]
FLOW RATE
MIN Q-INFLUENT
Minimum flow rate in inlet according to measurement signal
[m³/h]
MAX Q-INFLUENT
Maximum flow rate in inlet according to measurement signal
[m³/h]
0/4...20MA
Transfer range of 0/4–20 mA current loop, as set in the connected flow measuring instrument
MIN RET SLUDGE
Minimum flow rate of return activated sludge pump(s) (refer to
)
[m³/h]
MAX RET SLUDGE
Maximum flow rate of return activated sludge pump(s) (refer to
)
[m³/h]
Q RET RATIO
Ratio between measured flow rate and return activated sludge volume, for a return
activated sludge volume proportional to the measured flow rate (refer to
)
[%]
Q INFL SMOOTH
Smoothing of influent signal (refer to