Operation – Hach-Lange BUHLER 1027 wall mount automatic water sampler (BL series) User Manual
Page 42
Operation
Page 42
Manual Bühler 1027
REMARK:
The description of programming is a general document for all type of
samplers and thus some menus listed might not be relevant for your
type of sampler.
MAIN MENU (root):
Display
Description
1.1.1
**********************
Vxxxx
**********************
Information menu „Version of firmware“
1.1.2
**********************
TUESDAY
03 FEBRUARY 2009
09 H 01 MIN 44 SEC
**********************
Information menu „Date/Time“
Time and date are changed in menu „SETUP“.
1.1.3
**********************
OPERATING VOLTAGE
13.8 V
**********************
Information menu „Operating voltage“
Display of internal operating voltage (secondary voltage of power
pack).
1.1.4
**********************
PROGRAM NO. 1
TIME
INTERVAL HRS 0:06
FILLING TIME H 2:00
**********************
Information/selection menu „Program“
In this menu the desired program is selected. The program selected
at the moment and its parameters are displayed. By pressing the
ENT key, the program No. can be changed and one of the 6 user
programs can be selected. The current
program settings of each program are shown.
Remark:
This menu is displayed automatically after the last
step of each programming or program change.
Thus you can check immediately whether there are
any programming faults.
1.1.5
**********************
PROGRAM NO. 1
CHANGE
DELAYED START
*START
**********************
PROGRAMMING
A program (No. 01-06) selected in menu 1.1.4 can be
• started immediately
• started with a delay or
• changed.
1.1.6
**********************
MANUAL SAMPLE
EXTRACTION
**********************
MANUAL MODE
A single sample extraction into any bottle can be triggered
manually.