Hach-Lange BUHLER 1027 wall mount automatic water sampler (BL series) - Manual (Page 45)

Operation
Page 45 Manual Bühler 1027
1.1.4
**********************
PROGRAM NO. 1
TIME
INTERVAL HRS. 0:06
FILLING TIME H 2:00
**********************
Each programming is completed with this menu to have the pos-
sibility to check the program settings of the just created program.
Program No. 1 has been programmed with a time-proportional
program.
To start the program, press the „DOWN“ arrow key.
1.1.5
**********************
PROGRAM NO. 1
CHANGE
DELAYED START
*START
**********************
The just created program can either be
• started immediately
• started with a delay or
• changed
3. Programming of a „FLOW-DEPENDENT“ sampling program
If this sampling mode is selected, the sampler has to be connected to a flow meter which either
supplies an analogue signal (0/4 - 20mA) or a digital pulse.
The sample extraction is carried out according to this „flow signal“.
The programming of each of the three modes (0 -20 / 4 - 20 / digital) is very similar. Only single
menus are different (depending on the selected settings). The programming of these menus is
depending on the context and thus results from it accordingly.
The following example shows the programming of:
- Flow analogue 0 - 20mA /time-related bottle filling / max. number of samples per bottle limited.
1.1.4
**************************
PROGRAM NO. 2
TIME
INTERVAL HRS. 0:06
FILLING TIME H 2:00
**************************
Selection of the program number:
After having pressed the ENT key, a program number (1 to 6) can
be entered.
Confirm by pressing the ENT key.
Next menu: press the „DOWN“ arrow key.
1.1.5
**********************
PROGRAM NO. 2
*CHANGE
DELAYED START
START
**********************
PROGRAMMING
- Press the ENT key (cursor is displayed flashing)
- Press the „UP“ arrow key twice
- Confirm with ENT
2.2.1
**********************
PASSWORD
****
**********************
Enter the valid password (factory-set code is 6299).
Remark:
This is only required if a password has been activated in „Setup“->
„System settings“. If not, just press the ENT key and you will get
to the next menu!
If the right password has been entered, you will automatically get
to the next menu.