Hach-Lange BIOGAS User Manual - Manual (Page 34)

34
Standard Operations
5.10 Program instructions
Note: Only the Supervisor is allowed to program the
menus, Electrode, Reagent, and Method.
To select the Supervisor mode:
1. Press Stop for 3 seconds in the Main menu.
2. Enter the Supervisor code (see 5.6 on page 20 ).
3. Press 5 (Exit).
4. Select Return in mode = Supervisor.
For first time users, it is recommended to program the
instrument as follows:
1. Create the electrode(s) to be used to perform
the measurements.
2. Create the reagent(s) to be used during the
titration.
3. Create the method(s), which will consequently
use the electrode(s) and reagent(s) created in
the first two steps of programming.
4. Once you have finished programming, make
sure that NO question marks "?" are displayed
in the Reagent and Electrode tabs!
5.10.1 Enter a new electrode
1. Enter the Elekctrode menu and press 4
(Electrode library).