Hach-Lange BIOGAS User Manual - Manual (Page 8)

8
Section 3 Installation
3.1 Unpacking the instruments
The BIOGAS Titration Manager comes packaged with the following items:
• BIOGAS Titration Manager, one burette, zero version
• B525, Burette Stand, 25 mL, red cover with connection tubing
• Accessories for Titration Manager burette stand
• Set of Cables for Tiration Workstation (w/o serial PC Printer cable)
• Cell kit
• Titration Vessel, PP, 40-100 mL (pack of 10 pcs of 956-265)
• Titration Vessel, PP, 22-45 mL (pack of 10 pcs of 956-178)
• User Manual BIOGAS
• Basic User Manual BIOGAS, multilingual
• Method Guide for FOS/TAC (organic acids (FOS) and total inorganic carbon (TAC)), En-Ger
• Installation form (Fr-Eng-Ger)
Note: If any of these items are missing or damaged, contact the manufacturer or a sales
representative immediatly.
3.2 Operating environment
The following conditions are necessary to ensure correct instrument operation and accurate results:
• Place the instrument firmly on an even surface. Do not push any objects under the instrument.
• Maintain an ambient temperature of 5 to 40 ºC (41 to 104 ºF) for proper instrument operation.
• The relative humidity should be less than 80 %; moisture should not condense on the
instrument.
• Leave at least a 15 cm (6 in.) clearance at all sides for air circulation to avoid overheating of
electrical parts.
• Do not operate or store the instrument in extremely dusty, damp or wet locations.
• Keep the surface of the instrument and all accessories clean and dry at all times. Splashes or
spills on the instrument should be cleaned up immediately.
D A N G E R
Only qualified personnel should conduct the tasks described in this section of the manual.
N O T I C E
Protect the instrument from temperature extremes, including heaters, direct sunlight and other heat sources.