Hach-Lange BIOGAS User Manual - Manual (Page 46)

46
Standard Operations
6. Press the validation key.
7. Select the reagent from the proposed list.
8. Press 1 to start the calibration.
5.11.4 Run a method
Refer to Short-Form Reminder no. 6.
1. Select the method.
2. Install the electrode group to be used to perform
the analysis.
3. Install the reagent groups to be used to perform
the analysis.
4. Display the Main menu. and press 1 to start the
analysis.
5.11.5 Run a sequence
Refer to Short-Form Reminder no. 7.
1. Install the electrode group to be used to perform
the analysis.
2. Install the reagent groups to be used to perform
the analysis.
3. Display the Main menu.
4. Press 3.
5. Press 1.
6. Prepare the sample stack.
7. Display the Main menu and press 1 to start the
analysis.
5.11.6 Run a direct measurement
Refer to Short-Form Reminder no. 8.
1. Select the method.
2. Install the electrode group.
3. Display the Electrode menu.
4. Press 2 to start the measurement.
5. Select the electrode in the list.
Note: You can stop or start stirring by pressing 1.