Hach-Lange TITRALAB Users Guide - Manual (Page 25)

Introduction 25
1. Intr 1. Intr 1. Intr 1. Intr 1. Introduction oduction oduction oduction oduction
Warning !
The TitraLab 8xx system has been developed to meet the requirements
of volumetric titration applications. It is therefore aimed at experienced
users who have the knowledge required to operate the instrument and
implement the security instructions enclosed. Please remember that the
TitraLab 8xx system must not, under any circumstances, be used to
perform tests on living beings.
We accept no responsibility for using the TitraLab 8xx system and its
peripheral devices under conditions that are not specified in this
User's Guide.
Read me! Read me! Read me! Read me! Read me!
The interface of the Titration Manager has been specially designed to
clearly guide you through every step of the programming and running of
the analyses, whether you are a supervisor or a routine user.
An important part of this interface is to check and control the presence of
different elements necessary to run the defined application.
Working in Supervisor mode Working in Supervisor mode Working in Supervisor mode Working in Supervisor mode Working in Supervisor mode
When programming in “SUPERVISOR” mode, it is recommended to work
in stages. These stages
should be carried out in the order described
below:
To program a method To program a method To program a method To program a method To program a method
1. Define your electrode(s)
Identify electrodes (including temperature sensors) to be used for the
analysis.
Electrodes can be created from the following lists, Catalogue, Other or
Copy from. When creating the electrode, define if electrode calibration is
required (or not), if yes specify the “periodicity” of the calibrations and the
pH standards to be used. Refer to chapter 3.