Hach-Lange TITRALAB Users Guide - Manual (Page 57)

Programming guidelines 57
Programming electrode parameters Programming electrode parameters Programming electrode parameters Programming electrode parameters Programming electrode parameters
1. If Calibrate request = yes, enter the electrode definition
parameters and go to the last Edit electrode screen.
2. Press 1:
To enter Calibration parameters: general parameters
used during the calibration,
3. Press 2:
To enter Calibration solutions parameters concerning
the standards used for the calibration,
4. Press 3:
To enter the Results parameters concerning acceptation criteria
that you can set on the results.
5. Press 4:
To enter Printouts parameters defining the calibration report to
be printed.