Hach-Lange TITRALAB Users Guide - Manual (Page 66)

66 Chapter 3
Programming method parameters Programming method parameters Programming method parameters Programming method parameters Programming method parameters
1. Go to the last Edit method screen.
2. Enter the parameters. The parameters displayed will all depend on
the measurement type and mode selected.
3. Press 1:
To enter the Method parameters: general parameters
concerning the electrode and reagent (when required) used by the
method and the titration parameters.
4. Press 2:
To enter the Sample parameters: concerning the preparation of
the sample to be analysed.
5. Press 3:
To enter the Results parameters defining the results, the
acceptation criteria that you can set on the results and stoichiomet-
ric coefficients for the chemical reaction (if required).
6. Press 4:
To enter the Printouts: parameters defining the analysis
report to be printed.
7. Press 5:
To enter the QC data (only available when QC sample = Yes):
quality control parameters required when using QC samples.