CTI Products RCD Standard - Remote Comparator Display - Manual (Page 21)

MCN Remote Comparator Display Configuring a System
CTI Products, Inc. Using MCNCFG
68-10856-210
15
If you were working on a module set or screen file and had not yet saved it when
you selected the Files New Group Configuration menu command, the program
will give you a chance to save it.
Figure 4 - New Group Configuration Screen
6.4.1 Group Configuration Screen Description
The Group Configuration screen has entries for a total of 128 receiver (8 receivers
x 16 different modules). It includes a Receiver Name field and a Channel Name /
Note field.
The configuration screen has entries for the modules within that MCN Group.
The receiver number shown in the left column of the Group Configuration Screen
is made up of three parts (Grp:Mod:Rx).
1. Grp is the MCN Group number (00-FE) assigned to the Comparator
I/O Module(s) that you will be monitoring. This number can be
changed by using the Edit Group Number command.
2. Mod is the MCN Module number (0-F) assigned to the Comparator
I/O Module(s) that you will be monitoring. All 16 modules of a single
MCN Group are supported by a single Group Configuration File.
3. Rx is the number of the receiver (1-8) for that Comparator I/O Module.
The MCN Remote Comparator Display software supports 8 receivers
(bank 0) per MCN Comparator I/O Module.
NOTE: The Group and Module numbers must match the address of the
Comparator I/O Module being configured.