Lectrosonics Venue 3.9 - Manual (Page 13)

Digital Hybrid Wireless™ Modular Receiver System
Locking Out the Front Panel Controls
From the overview screen press the knob to enter the
Top Menu and select LockSet. Rotate the knob either
direction to select LOCKED or UNLOCKED.
When the settings are LOCKED no changes can be
made to the configuration. If an attempt is made to
change a setting, the LCD will flash a reminder that the
settings are locked.
Selecting the Noise Reduction Mode
Two different DSP-based noise reduction modes are
available:
1. Access the SmartNR Setup Screen.
2. Select Receiver Module and rotate the knob to the
desired setting - NORMAL, FULL or OFF.
Selected Receiver
Selected Receiver SmartNR Mode
is Highlighted
The NORMAL mode is the factory default. It removes
subtle high frequency audio noise but does not affect
the modulated audio in the signal. In the FULL mode,
high frequency audio noise is supressed more aggres­
sively, including noise in the local environment. OFF
applies no noise reduction to the signal.
Listen to the audio signal as you rotate the knob and
select the mode that best fits the situation.
Note: If the selected Receiver Module is part of
a ratio or frequency diversity pair, then setting
the audio output level for one receiver in the pair
automatically sets the other receiver in the pair to
the same setting.
Walk Test the System
Turn everything on and walk each transmitter through
the area where it will be used to check for reliable RF
coverage and audio quality. The control panel GUI has a
convenient Walk Test Recorder which is very helpful in
doing this. Refer to the help file in the supplied software.
Rio Rancho, NM 13