Lectrosonics Venue 3.9 - Manual (Page 9)

Digital Hybrid Wireless™ Modular Receiver System
Setup and Configuration Using LCD
The front panel knob, buttons and LCD enable complete
complete system setup for all operating parameters.
Resetting to Factory Defaults
Resetting to Factory Defaults can be a time saver for
setting up the system. Start with the power turned off,
then hold Receiver Select buttons 5 and 6 while power­
ing up the system.
Receiver Select
Buttons 5 and 6 POWER Switch
The Factory Default Settings are:
Level +00 dBu
Phase NORMAL
TxBatt 9V ALK
SmartNR NORMAL
PilotBP NORMAL
Compat Dig. Hybrid
Tuning NORMAL MODE
DivMode Switched
LockSet NOT LOCKED
System Setup Checklist
Several mandatory settings are required before the Ven­
ue will begin working. It is generally best to complete
these steps in the sequence shown.
• Select compatibility modes
• Select diversity modes
• Find clear channels and set transmitters to
match the receivers
• Adjust audio output level
Additional settings are used for fine tuning, diagnostics
and control panel lockout, a final walk test is always a
good idea.
• Audio signal phase
• Transmitter battery type
• Pilot tone bypass
• Control panel lockout
• Smart Noise Reduction mode
• Walk test
Select Compatibility Modes
Five compatibility modes are available for each receiver
module to match various transmitter types:
Mode LCD Appearance
Digital Hybrid HYB
Mode 3 M.3
200 Series 200
100 Series 100
IFB IFB
Mode 6 M6
The Compatibility Mode for each receiver module must
match the transmitter associated with that module.
1. To set a receiver’s compatibility mode,
navigate to the Compat Setup Screen.
2. Select the receiver to adjust with the button
under the LCD.
3. Rotate the MENU/SELECT control to
display the desired Compatibility Mode. An
abbreviation for the mode selected will appear
in the LCD for each receiver.
Compatibility Mode
4. Continue for all receivers installed.
Shortcut
With the parameter screen showing, press and hold
the button under the selected receiver. Then press
the buttons under the other receivers that are to
receive the same parameter. The LCD will update to
confirm the parameters have been copied.
Rio Rancho, NM 9