Lectrosonics Venue 3.9 - Manual (Page 8)

Venue
Powering On and Off
When the Venue receiver is first powered up the LCD
will show the firmware revision and the tuning range
of the host assembly. The narrowband version of the
VRM covers a 50 MHz bandwidth, which includes two
adjacent frequency blocks. The firmware in the narrow­
band version launches a boot sequence automatically
to detect the installed modules.
The receiver will automatically start the detection se­
quence to identify the modules installed.
When detection is complete, the LCD will briefly display
the frequency blocks of the installed modules.
At the end of the boot sequence the LCD displays an
overview of all six channels.
In normal operation with all six channels running, the
overview display will include:
• Audio level
• RF level
• Diversity antenna phase activity
• Pilot tone status
• Transmitter battery status
Relative Audio Level
Individual Receivers
1 2 3 4 5 6
Pilot Tone
Monitoring
Status
Antenna Phase
Battery Monitor Relative RF Signal Strength
Overview Screen
In this example, channels 2 and 3 have a receiver
module installed, but the matching transmitters are not
turned on. Channel 6 has no receiver module installed.
Once the initial startup is complete, go to the next
section of this manual for details on setup and
configuration options.
To power off the unit, press and hold the red power
switch for several seconds. The LCD will display a mes­
sage briefly then power down.
Receiver Detail Screen
Pressing one of the six front panel buttons below the
LCD will pop up the Detail screen for the corresponding
receiver to show all current settings, levels and status.
Pilot Tone Transmitter Frequency
Monitoring Status Select Switch Settings
RF Signal
Strength
Receiver Module
Location
Operating
Frequency
Antenna Phase
Battery Monitor
TV Channel
Audio Level Meter
Tuning Mode
Receiver Detail Screen
LECTROSONICS, INC. 8