Lectrosonics Venue 3.9 - Manual (Page 14)

Venue
Installing LecNet2 ™ Software and USB Driver
Part of the LecNet2 ™ software package is the VRpanel
for the Venue Receiver. This Graphical User Interface
(GUI) is designed to allow easy setup and monitoring of
the Venue Receiver using a computer system running
the Windows ® 2000, XP or Vista TM operating system.
Installing LecNet2 ™ Software
1. Remove any previously installed versions of Lec­
Net2 ™ software. (This will ensure you are using the
latest release.)
2. Insert the LecNet2 ™ program disk supplied with the
Venue Receiver into the CD-ROM drive on the com­
puter system that will be used to set up and control
the Venue Receiver.
3. The CD should automatically start the installation
procedure. If it doesn’t, click “Start” on the Windows
Task Bar then click “Run...” Enter the Drive letter
(“E” in the example) followed by “Setup.exe” as
shown below.
4. Follow the on-screen instructions to install the
LecNet2 ™ software and the VR Panel for the Venue
Receiver.
Installing the LecNet2 ™ USB Driver
There are two ways to connect a Windows ® -based com­
puter system to the VRM: a USB cable or an RS-232
cable. Although the USB port offers increased speed
and convenience over standard RS-232 links, it does
require the installation of a LecNet2 ™ USB driver.
The LecNet2 ™ USB driver is not part of the standard
Windows ® 2000 and XP driver libraries; therefore, con­
necting a computer system to the VR for the first time
differs from subsequent installations. There are a few
differences between installing the LecNet2 ™ USB driv­
ers on Windows 2000 versus Windows XP systems.
USB Driver Installation (Windows XP) - First Time
When the VR is connected to a Windows XP computer
system for the very first time, the Windows ® Found New
Hardware Wizard automatically opens. Use the follow­
ing procedure to install the LecNet2 ™ USB driver using
the Wizard.
1. Place the LecNet2 ™ Installation Disk in the PC’s
CD-ROM drive.
2. On the first page of the Wizard, select Install from
a list or specific location (Advanced) and click
“Next>” to continue.
3. Select “Search for the best driver in these loca­
tions.”, then check the box for “Search removable
media (floppy, CD-ROM...)” and click Next> to
continue to the next page..
4. Windows will search the CD for the driver and when
it has found it. If a dialog box opens warning you
that the driver has not passed Windows Logo Test­
ing, click “Continue Anyway.”
LECTROSONICS, INC. 14