Lectrosonics Venue 3.9 - Manual (Page 18)

Venue
Help Menu
Help provides access to the online Help file, VRpanel
demonstration mode and an About Box featuring the
VRpanel’s current version number.
The Help file offers users detailed information on the
setup and operation of the Venue System.
Client Area
The Client Area holds one or more panes, each graphi­
cally representing one VR system. Each pane, in turn,
holds from one to six plug-in receiver modules (receiver
modules). An information line at the top of each pane
identifies the VR System USB Identification and fre­
quency block range.
VR System
Information
Installed
Reciever
Modules (Plug­
in Receivers)
Popup Menu
Because VRpanel is capable of monitoring and control­
ling more than one VR system, none of the commands
available through the Menu Bar are available for individ­
ual systems. To work directly with a specific VR system,
right-click anywhere in its pane to open a popup menu.
This menu includes commands for configuring the VRs
receiver modules, running the spectrum scanner, real-
time recording of a walk test, resetting the current VR
system back to factory defaults or deleting the current
VR system from VRpanel.
Set Up VR
The Set Up VR dialog is used to control all the stored
settings for the currently selected VR system.
This dialog allows for convenient selection and setup of
all installed receiver modules in the currently selected
VR system and global settings for the VRM. It consists
of three sections: Plug-In Receiver Selection, Plug-In
Receiver Settings and Master Settings. Changes to any
of the Plug-In Receiver Settings are done in real time.
Spectrum Scan
There are three sections to the Spectrum Scan dialog
box: cursors, spectrum scanner and command buttons.
Cursors controls cursor selection (and thus the tuning
of the selected receiver module). The cursor for the
selected receiver module appears as a dashed line in
the spectrum scanning section and its frequency detail
is displayed to the right of the cursor radio buttons.
This information includes the frequency block number,
transmitter frequency select switch settings, operating
frequency and TV channel.
When this dialog initially appears, a cursor will be
located at the set operating frequency for each installed
receiver module, or receiver module pair. Clicking Run
starts the spectrum scanner. A separate cursor moves
to identify the real-time location of the scan within each
frequency block.
All Receivers in Switched Diversity Mode
Cursor Select Receiver Module
Frequency Locations
Moving any of the cursors automatically changes the
operating frequency for the corresponding Receiver
Module, or module pair depending on the diversity
mode.
Clicking Stop suspends the scan. Clicking Run re­
sumes the scan. Clicking Clear stops the scan and
clears the spectrum data.
LECTROSONICS, INC. 18