Blade guard, Installing the blade guard, Removing the blade guard – Diamond Products CC6566 User Manual

Page 18

Advertising

7. Place the wedge lock washer onto the blade

shaft bolt and insert the bolt into the blade
shaft.

8. Tighten the bolt by hand to secure the inner and

outer flange together.

9. Reattach the blade guard or pivot the front of

the guard down and over the blade to secure.

Blade Guard

WARNING

 DO NOT operate the saw with the blade guard

raised or removed.

 DO NOT remove the blade guard with the

engine running.

 Blade exposure when cutting should not

exceed 180°.

 Always pivot the front of the blade guard 180°

(fully upward) and secure with pin so the
guard does not swing down unexpectedly,
causing serious injuries.

The blade guard shields the blade and must always
be in place when operating the saw. Be sure to use
a guard that matches the blade size.

Installing the Blade Guard

1. Regularly inspect the blade guard water tubes

for cuts, slurry, and/or debris. Clean them using
a wire brush or replace the tubes as necessary.

2. Place the tapered mount from one side of the

blade guard down onto the tapered blade guard
mount on the frame base.

Figure 14: Lowering the Guard

3. Insert the lock pin, connected to the lanyard,

into the tapered blade guard mount hole.

4. For the 36-42” blade guards; place the blade

guard cap screw through the hole on the rear
side (facing away from the saw) of the blade
guard, and then tighten the screw into the
threaded hole on the side of the frame base.

Figure 15: Blade Guard Cap Screw Hole

5. Connect one end of the water supply hose to

the water valve and the other end to the blade
guard hose fitting.

Figure 16: Blade Guard Hose Fitting

Removing the Blade Guard

1. Disconnect the water supply hose from the

blade guard hose fitting.

2. Remove the lock pin from the tapered blade

guard mount hole.

3. For the 36-42” blade guard; remove the blade

guard cap screw from the threaded hole on the
side of the frame base and from the blade
guard.

4. Use the handle on the blade guard to rock the

guard back and forth while lifting the guard off
of the tapered blade guard mount.

Advertising