Diamond Products CC6566 - Manual (Page 19)

CC6566 - CC6566-3 Concrete Saw Manual
Flange Guard
Installing the Flange Guard
1. Remove the lock pin from the tapered blade
guard mount hole.
Figure 17: Lock Pin
2. The backside of the flange guard has two
tapered mounts. Place the tapered mount (that
best fits the flange guard over the blade flange)
down onto the tapered blade guard mount.
3. Insert the lock pin into the tapered blade guard
mount hole to secure the flange guard.
Removing the Flange Guard
1. Remove the lock pin from the tapered blade
guard mount hole.
2. Lift the flange guard off of the tapered blade
guard mount.
Figure 18: Flange Guard
3. Reinsert the lock pin into the tapered blade
guard mount hole.
Water Supply
The water supply cools the blade and minimizes
dust when cutting. Note: Always test the water
supply for adequate pressure and flow before
cutting.
Using the Water Supply
1. Connect the water source hose to the horizontal
hose fitting on the left side of the saw.
2. Connect the water supply hose to the vertical
hose fitting on the right or left side of the saw,
depending on the cutting task.
3. Connect the other end of the water supply hose
to the blade guard hose fitting on the same side
of the saw. Note: Disconnect and reconnect the
hose when moving the blade guard to the
opposite side of the saw.
4. Turn on the water valve to start the water flow
and turn off the water valve to stop the water
flow. The water flow between these two points
increases/decreases based on the valve’s
position. Note: Turn on the water just before
cutting to avoid wasting water.
5. Disconnect the water supply hose from the
blade guard hose fitting when the cutting job is
complete.
Figure 19: Left Water Valve
Figure 20: Right Water Valve
19