Diamond Products CC6566 - Manual (Page 27)

CC6566 - CC6566-3 Concrete Saw Manual
Inner Blade Flange
Figure 33: Inner Flange
Installing the Inner Blade Flange
1. Check the inner flange for damages and clean
or replace as necessary.
2. Remove the setscrew from the back of the inner
flange using an Allen wrench.
3. Place the inner flange onto the indented portion
of the blade shaft.
4. Apply Loctite 262 (red) or an equivalent to the
setscrew threads.
5. Place the setscrew into the inner flange
setscrew hole and tighten it down to the blade
shaft key to secure the inner flange.
Removing the Inner Blade Flange
1. Remove the setscrew from the back of the inner
flange using an Allen wrench.
2. Remove the inner flange from the blade shaft.
3. Check the inner flange for damages and clean
or replace as necessary
4. Place the setscrew into the inner flange
setscrew hole and tighten to secure.
Rear Wheels
Inspect the rear wheels regularly for damages or
wear and replace as necessary.
1. Unscrew the trantorque bushing and remove
one of the rear wheels.
Figure 34: Trantorque Bushing
2. Place the new wheel onto the rear axle.
3. Place the trantorque bushing into the wheel
hole and tighten the bushing to 175 ft-lb (237
Nm). Note: Failure to properly tighten the
bushing may cause the wheel to fall off the saw.
4. Repeat steps 1–3 to replace the second wheel.
Battery
WARNING
 Ignitable explosive gases are
emitted from the battery. DO
NOT expose the battery to
sparks or open flames, and keep the area
around the battery well-ventilated.

Disconnect the battery when performing
maintenance.
CAUTION
 Use a proper battery tester, such as a
voltmeter, to test the battery strength.
 Use protective eyewear or a face shield,
and avoid contact with the skin when
handling a battery.
Battery Type
12 Volt, Group 24
Servicing the Battery
1. Remove the battery brace lock nuts and battery
brace.
27