Diamond Products CC6566 - Manual (Page 26)

Maintaining the CC6566 and CC6566-3
Failure to read and comply with the maintenance
instructions provided in this manual prior to
performing maintenance may result in serious
injuries and/or death, and may harm the saw. DO
NOT attempt to perform maintenance on the saw if
you are not properly trained for it, or are not
supervised by an experienced person.
Refer to the CC6566 and CC6566-3 Parts’ Lists for
additional information and part diagrams when
performing maintenance tasks. Refer to the engine
manual and manufacturer as the primary source for
all safety, operations, and maintenance instructions
for the engine. Contact the saw and/or engine
manufacturer with any additional questions.
Remove all necessary guards and access panels
prior to servicing the saw. Replace prior to
operating.
Maintenance Overview
Complete the following maintenance tasks as
required. DO NOT delay maintenance! Print the
Daily Maintenance Task Chart from Appendix B to
keep track of maintenance tasks completed.
Daily and/or Regularly
 Inspect belts daily for tension and wear and
replace and/or re-tension as necessary.
 Inspect saw for damages.
 Tighten loose nuts and bolts.
 Check fuel level and fill as necessary.
 Check engine oil level and fill as necessary.
 Check hydraulic oil level and fill as necessary.
 Remove slurry and debris from radiator.
 Look for fluid leaks.
 Re-tension rear drive chain as necessary.
 Check oil level in oil expansion tank and fill as
necessary.
 Check air filter indicator.
125 Hours
 Change engine oil.
 Replace oil filter.
500 Hours
 Replace in-line fuel filter.
 Replace fuel filter.
 Check battery, battery cables, and cable
connectors and clean as necessary.
 Replace outer primary air filter.
 Replace inner safety filter.
 Change oil bath blade shaft oil.
Note: Refer to the engine/motor manual and
manufacturer for a full maintenance schedule and
additional maintenance information.
Handlebars
The handlebars generally require little or no
maintenance and, when used correctly, should
remain in good condition. Inspect the handlebars
occasionally for bending, unusual cracks, and/or
breakage. Replace them immediately when
damaged.
Part Lubrication
WARNING
 DO NOT grease parts with
the engine running unless
stated otherwise.
Lubricating parts on schedule increases the saw’s
efficiency and life. Use NLGI No. 2 premium
lithium-based grease when lubricating parts.
Front Axle
Lubricate the front axle grease fitting every 40
hours of operation. Lubricate both pillow block
bearing grease fittings every 40 hours of operation.
Rear Axle
Lubricate both pillow block bearing grease fittings
every 40 hours of operation.
PTO
Add three pumps of grease to PTO every 25 hours.
Use high temperature, extreme pressure, Lithium
based grease.
26