Diamond Products CC6566 - Manual (Page 32)

Figure 45: Linkage Assembly Nuts
3. Remove tools from the area. Start the engine to
check the speed control lever for accuracy.
4. Turn the engine off and readjust the threaded
nuts as necessary.
5. Adjust the cap screw at the speed control
lever’s pivot point to change the amount of
friction felt when moving the speed control
lever.
Drive Alignment
Adjust the rear drive, as necessary, when the saw
leads more to one side when cutting.
Adjusting the Rear Drive
1. Turn the engine off and let the saw cool down.
2. Loosen the two left rear axle pillow block
bearing bolts. DO NOT remove them.
Figure 46: Rear Axle Pillow Block
Bearing Bolts
3. Turn the rear axle adjustment bolt on the back
of the frame base counterclockwise if the saw
leads more toward the right, or clockwise if the
saw leads more toward the left. DO NOT force
adjustments.
Figure 47: Rear Axle Adjustment Bolt
4. Retighten the pillow block bearing bolts to
secure the alignment and readjust as
necessary.
Oil Bath Blade Shaft /Oil Expansion Tank
The oil expansion tank supplies oil to the oil bath
blade shaft. Add oil up to the full cold line on the
expansion tank as necessary. Change the oil bath
blade shaft oil annually (500 hours).
Changing the Oil - Single Speed
1. Lower the saw to the floor so it is level.
2. Place an oil tray underneath the blade shaft’s
magnetic oil drain plug.
3. Remove the oil drain plug to drain the oil.
4. Replace the plug when the oil is drained.
5. Remove the casing vent line by unscrewing the
3/8” pipe fitting on the top of the casing.
6. Add an automatic transmission fluid (ATF) or an
equivalent into the housing until full.
7. Replace the casing vent line.
32