Diamond Products CC6566 - Manual (Page 46)

Table 5: Troubleshooting (cont.)
Symptom Problem Solution
6. Blade does not cut straight.
Misaligned rear axle? Adjust rear axle alignment.
Excessive force applied while
sawing?
Reduce forward speed.
Wrong blade for application?
Contact dealer or manufacturer of
blade.
7. Short belt life.
Loose belts causing slippage?
Check belt tension on a regular
basis.
Sheaves misaligned?
Use straightedge to check blade
shaft sheave alignment.
Worn sheave grooves?
Check for groove wear and replace
as needed.
Belts contacting pavement?
Inspect and replace worn front skid
plates.
Belts contacting pavement?
Adjust front axle maximum depth
stop bolt for belt clearance.
Mismatched belt set?
Replace with new set of matched
belts. DO NOT mix old and new
belts.
Overheating of PTO?
Check belt tension. Lubricate PTO
every 25 hours.
46