Diamond Products CC6566 User Manual
Page 37
CC6566 - CC6566-3 Concrete Saw Manual
Three Speed
1.
Inspect the belts for fraying, stress cracks,
and/or breakage and replace immediately if
there are damages.
2.
Test the belt tension. Proceed to step 3 if the
belts need tensioning. Operate the saw as
needed if no tension adjustments are required.
3.
Locate the belt guard on the left side of the
saw. Loosen and remove the seven hex head
cap screw and bolts located on the side and
rear of saw. Remove belt guard.
Figure 59: Belt Guard Bolts – Side (3)
Figure 60: Belt Guard Bolts – Rear (4)
4.
Locate detent pin in rear of the saw. Retract pin by
pulling outward and turning 90
to lock open.
Figure 61: Detent Pin
5.
Locate the belt tensioner lead screw on the
front of the saw frame. To loosen the belts turn
the lead screw clockwise. This will allow the
gear box to tilt back. To tighten the belts turn
the lead screw counter clockwise. Test the belt
tension and readjust the tension bolt as
necessary. DO NOT exceed the
manufacturer’s belt tension setting.
Figure 62: Belt Tensioner Lead Screw
6.
Once the blade drive belts are tightened
properly, lock the detent pin. Turn detent pin
until it snaps back into place.
7.
Replace belt guard and retighten the seven hex
head cap screw and bolts.
37