Nova-Tech CBK Series - Manual (Page 17)

© Adam Equipment Company 2007
15
10.6 LIMITS STORING AND RECALLING
The scale can store up to 10 sets of high and low limits in memory along with
the weighing units in use (including
pcs for parts counting and % for percent
weighing) as well as settings for the beeper and bar graph.
During Check weighing the current limits can be stored or previously stored
units can be recalled.
Press the [ Lim] key. If you are
already in the check weighing mode the
display will ask if you wish to store the
current limits by showing “StOrE” or recall
another set of limits by showing “rECALL”.
The
[ Lim] key can be used to toggle
between “StOrE” and “rECALL”.
If you want to store the limits press
[Tare] when “StOrE” is displayed. The
display shows “St ”. Enter a number
corresponding to the desired memory
location (0 to 9). “St X” will be displayed
for 2 seconds indicating the location X
where the current limits, weighing units
and settings for the beeper and bar
graph are stored. The scale will continue
to work with the current settings as
active.
If you wish to recall any of the pre-stored
limits, press
[Tare] when “rECALL” is
displayed. The display shows “rEC ”. Enter
the number corresponding to the desired
memory location (0 to 9) to be recalled.
“rEC X” will be displayed for 2 seconds
indicating the values stored in the
location “X” is being recalled. The scale
will change to the recalled limits,
weighing units and settings for the
beeper and bar graph.