Nova-Tech CBK Series - Manual (Page 20)

© Adam Equipment Company 2007
18
NOTE:
1. The accumulation function is available only during weighing. It is
disabled during parts counting or percent weighing.
2. The accumulated weights will be stored in either kg (for g or kg) or lb
(for lb, oz or lb:oz).
3. If at any time the weighing units are changed, the accumulated data will
be lost.
10.8.1 Manual Accumulation
When the scale is set to manual accumulation, the weight displayed will be
stored in the memory when the
[Print] key is pressed and the weight is
stable.
• Remove the weight and press [Print] when the scale is at zero.
The display will show "ACC 1" and then the weight in memory for 2
seconds before returning to normal. The weight can be output to
a printer or PC using the RS-232 interface.
• When the scale is at zero place a second weight. Press [Print] to
accumulate the weight. Remove the weight and press [Print].
The display will show "ACC 2" for 2 seconds and then show the
new total.
• Continue until all weights have been added. This can continue for
up to 99 entries until the capacity of display is exceeded.