Nova-Tech CBK Series - Manual (Page 19)

© Adam Equipment Company 2007
17
if 3500g is placed on the scale and percent weighing is selected, the
display will show 100.00%. Remove the 3500g weight and place a
3000g weight. The display will show 85.7% as 3000g is 85.7% of
3500g.
• The number of decimal points will depend on the weight used. A
smaller weight will show only “100%” while a larger weight might show
“100.00%”.
• If the scale was showing zero weight when entering this function, then
the user must manually enter the weight to be set as 100%. Press
[Tare] to accept the reference weight. The display will show “0.00 %”.
• If the scale shows “x x . x x %”, which is the last weight used as a
reference, press [CE] to clear and use the numeric keypad to enter a
new value. Press [Tare] to accept the new reference weight.
• The weight entered must be greater than 50 scale divisions.
• Press [Unit] to return to weighing.
NOTE:
The display may jump by large numbers unexpectedly if small weights are
used to set as 100% reference. For example, if only 23.5g is placed on a
scale with 0.5g increments and is set to 100%, the display will show
100.00%. However a small change of weight will cause the display to jump to
102.13% as an increase of one scale division (0.5g) to 24.0g will be
equivalent to an increase of 2.13%.
10.8 ACCUMULATED TOTAL
The scale can be set to accumulate when a weight is added to the scale
automatically or manually by pressing
[Print]. See Section 13.2.