Nova-Tech CBK Series - Manual (Page 26)

© Adam Equipment Company 2007
24
13.0 PARAMETER SETTINGS
Pressing the [Func] key allows the user to access the parameters for
customising the scale. The parameters are split into 3 groups-
1. Check weighing parameters,
2. RS-232 parameters and
3. Scale parameters
• When [Func] is pressed, display will first show “FUnC 1” for Check
weighing parameters.
• Enter [2] for RS-232 parameters or [3] for Scale parameters or press
the [Func] key to advance through the groups “FUnC 1”, “FUnC 2” and
“FUnC 3”. Press [Tare] to enter the desired group of parameters.
• Press [Zero] to return to the group “FUnC 1”. If you press [Zero] again,
the scale will exit the User Parameter section and return to normal
weighing.
13.1 CHECK WEIGHING PARAMETERS
• Shortcut to enter this group is to press and hold the [Func] key for 4
seconds. The display will go directly to “FUnC 1”.
• Press [Tare] to enter the group.
• Press [Func] to scroll through the parameters and press [Tare] to enter
a parameter setting.
• Press [Func] to view the options for setting.
• Press [Tare] to confirm the change and then advance to the next
parameter by pressing the [Func] key.
This group of parameters-
- enables or disables the percent weighing
- sets the lock for re-setting the check weighing limits
- enables or disables the check weighing LED indicator
- enables or disables the check weighing alarm
- sets the User Password for check weighing
- enables or disables the negative check weighing