Pach and Company AeGIS 8000 Series Manual - Manual (Page 14)

Chapter 3
PROGRAMMING
The AeGIS 8000 Series can be programmed LOCAL via built-in keypad or REMOTE via modem (see Management Software
Manual for remote programming).
LOG ON TO PROGRAMMING MODE
Two ways to log on to programming mode:
Using a valid master code
Step 1: PRESS 0 AND # SIMULTANEOUSLY THEN RELEASE, the display screen will stop scrolling. Repeat the process
again if the display is still scrolling.
Step 2: Enter the valid 4-digit master code (default master code is 0000). The display will show:
Step 3: Proceed to programming table 3.1 to continue programming. If the system is in idle for 30 seconds, the display will
return to the scrolling mode.
Without a valid master code or forgot the master code
Step 1: Open the panel (key must be used). If you do not have a key, call the manufacturer to obtain a replacement key
with nominal charge.
Step 2: Locate a square “RED” or “GREEN” button on the board and press and release it, the display will show:
xxxx is the 4-digit master code.
then proceed to step 3. If the display is showing:
stop and call the manufacturer for a memory replacement.
Step 3: Press #, proceed to programming table 3.1.
TABLE 3.1 PROGRAMMING FUNCTION CODE
Pach and Company Chapter 3 Page 7
AeGIS 8000 Series PROGRAMMING
Select Func: _ _
Master Code: x x x x
Master Code: * * * *
FUNCTION CODE PROGRAMMING
*
1. Exit the programming mode by pressing the
*
once or twice.
2. Clear the programmed name, phone number and access code by
pressing
*
.
3. Press
*
then the 4-digit access code to gain access via the system’s
keypad.
# Press # to accept the program.
00
REPLACE THE SYSTEM’S MASTER CODE
(Default setting is 0000)
The master code is used to log on to
programming mode.
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _