Pach and Company AeGIS 8000 Series Manual - Manual (Page 25)

Pach and Company Chapter 3 Page 18
AeGIS 8000 Series PROGRAMMING
FUNCTION CODE PROGRAMMING
75
ENABLE OR DISABLE KEYPAD PRESS BEEP
(Default setting is 1 for enable)
ENABLE = Keypad will beep when the key is
pressed
DISABLE = Keypad will not beep when the key
is pressed
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 75 then press #, the display will show
Step 3 Enter • 1 = Enable
• 0 = Disable
then press #
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
76
TURN OFF AND ON SPEAKER BEEP WHEN
DOOR IS UNLOCKED
(Default setting is 1 for ON)
ON = Speaker will beep when door is
unlocked.
OFF = Speaker will not beep when door is
unlocked.
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 76 then press #, the display will show
Step 3 Enter • 1 = Speaker beep is ON when door is unlocked
• 0 = Speaker beep is OFF when door is unlocked
then press #
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
77
ENABLE OR DISABLE PBX
(Default setting is 0 for disable)
ENABLE = Certain PBX machine requires to
dial 9 (requesting an outside line) before dialing
the phone number, therefore function code 77
must be enabled. NOTE: If function code 77 is
enabled, the system cannot dial another
extension on the PBX.
DISABLE = Direct dial without requesting an
outside line.
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 77 then press #, the display will show
Step 3 Enter • 0 = disable the PBX then press #, proceed to step 5
• 1 = Enable the PBX then press #, the display will show
Step 4 Enter the number to request the outside line, i.e. 9 then press #
Step 5 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
Select Func: _ _
BEEP On=1OFF=0 : 1
Select Func: _ _
UnlockBeep (1,0) 1
Select Func: _ _
PBX (1,0): 0
PBX#: _ _ _ _