Pach and Company AeGIS 8000 Series Manual - Manual (Page 24)

Pach and Company Chapter 3 Page 17
AeGIS 8000 Series PROGRAMMING
FUNCTION CODE PROGRAMMING
Step 3 Enter • 1 = enable
• 0 = disable
then press #
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
72
LOCK-OUT COUNT
(Default setting is 3)
The system will be disabled if invalid access
code has been entered according to the lock-out
count setting. The system will ignore further
access code entries for 90 seconds.
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 72 then press #, the display will show
Step 3 Enter the lock-out count (1-9) and then press #
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
73
TONE OR PULSE DIALING
(Default setting is 1 for tone)
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 73 then press #, the display will show
Step 3 Enter • 1 = Tone
• 0 =Pulse
then press #
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
74
ENABLE OR DISABLE AUTO ANSWER
(Default setting is 1 for enable)
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 74 then press #, the display will show
Step 3 Enter • 1 = Enable auto answer
• 0 = Disable auto answer
then press #
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
Select Func: _ _
LOCK-OUT CNT: 3
Select Func: _ _
TONE=1 PULSE=0: 1
Select Func: _ _
AUTO ANSWER=1 :1