Pach and Company AeGIS 8000 Series Manual - Manual (Page 6)

Relay Output: Form C Dry Contact 120 VAC 10A/ 24VDC 10A/ 250VAC 7A
Memory Type: EEPROM
Tone Detection: Crystal controlled, capable of detecting short bursts 80 ms
Mounting: Surface and Full-Flush, outdoor or indoor.
Construction: 16 gauge cold rolled steel back box and brushed stainless steel or brushed brass plating faceplate.
Dimensions (HWD):
10-13/16” x 8-5/8” x 3-3/4” (Surface Mount Main Lobby Control Panel)
10-13/16 x 8-3/8 x 2-7/16” (Full-flush Main Lobby Control Panel)
Full-Flush Mounting Ring (included with the Full-flush main Lobby Control Panel)
Inside: 11-1/8” (H) x 8-11/16”(W) x 2-5/8”(D)
Outside: 14-5/16” (H) x 12-1/8” (W)
Shipping: 11 lbs or 5 kg (Approximately).
Specifications subject to change without prior notice
Accessories and Replacement Parts:
1.3 UNPACKING THE SYSTEM
After you unpacked the package, check the serial number on the printed circuit board, cabinet and warranty card, they must
match. If they do not match, please contact Pach and Company toll free number at (888) 678-7224. All the items listed below
come with the AeGIS 8000 Series. Some of the parts may not be listed below. If you have missing items, please contact your
distributor or Pach and Company at (888) 678-7224.
• AeGIS 8000 System.
• XMFR (Power Transformer, 12VAC 40VA).
• 3-pin terminal connector (inside the system)
• 5-pin terminal connector (inside the system).
• 7-pin terminal connector (inside the system).
• Two - Key sets (2 keys per set).
• RJ-11 adapter (inside the system).
• Owners Manual.
• Software CD.
• Warranty Card.
1.4 Limited Warranty
Pach and Company new products are warranted to be free of defects in material or workmanship for a period of two
years, (24 months), from the date of purchase. This warranty extends only to wholesale customers who buy direct
from Pach and Company or through Pach and Company’s normal distribution channels.
Pach and Company does not warrant this product in any way to the end user consumer. Consumers must obtain
warranty information from the selling dealer and/or installer as to the nature of the dealer’s warranty, if any. All con-
tact to Pach and Company from the end user consumer will be referred to the consumer’s selling dealer and/or
installer.
There are no obligations and/or liabilities on the part of Pach and Company for consequential damages arising out
of or in connection with use or performance of Pach and Company products or other indirect damages with respect
to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. Any use or change to Pach
and Company products not expressly approved by the manufacturer, and performed by an authorized
dealer/installer will immediately void the warranty. All implied warranties, including warranties for marketability as
well as implied warranties for suitability, are valid only until the warranty expires or is voided, whichever comes
first.
This Pach and Company Limited Warranty is in lieu of all other warranties express or implied and all Pach and
Company warranties are subject, but not limited, to the following conditions.
I. NEW PRODUCT POLICY
Pach and Company Chapter 1 Page 2
AeGIS 8000 Series GETTING STARTED