Pach and Company AeGIS 8000 Series Manual - Manual (Page 17)

FUNCTION CODE PROGRAMMING
Step 6 • To change the access code, press * then enter a new one then
press #.
• To keep the current access code, press #
Step 7 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
03
DELETE AN EXISTING TENANT
You must know the directory code to delete an
existing tenant. Delete any unused directory to
free the memory.
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 03 then press #, the display will show
Step 3 Enter the tenant directory code to be deleted then press #, the
display will show
If the directory code does not exist, the display will show
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
04
CLEAR ALL TENANT DIRECTORY CODES
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 04 then press #, the display will show
Step 3 • Press 13 then #, the display will show
then proceed to step 4 or
• Press * to cancel deletion and you will hear “one long beep” and
proceed to step 5.
Step 4 Press 5 the # to delete or press * to cancel deletion.
Step 5 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
Access Code: current code
Pach and Company Chapter 3 Page 10
AeGIS 8000 Series PROGRAMMING
Select Func: _ _
Delete Dir: _ _ _
(Dir Code) is deleted !
Error on Delete !
Select Func: _ _
Delete all ? 13
Are you sure ? 5