Pach and Company AeGIS 8000 Series Manual User Manual
Page 22
Pach and Company
Chapter 3
Page 15
AeGIS 8000 Series
PROGRAMMING
FUNCTION CODE
PROGRAMMING
20
RELAY 1 (DOOR 1) REMOTE ACCESS
NUMBER SELECTION
(Default setting is 9)
Remote access number is used for all tenants to
provide remote access to their visitor(s). This
number can be changed. The AeGIS 8000
Series have two relay, the second relay remote
access number is set for number 8. If you
change the remote access programming on
relay 1 to a different number, do not select
number 8, if you do so, the second relay cannot
be released using the 8.
Step 1
Log on to programming mode, see instruction above. The display
will show
Step 2
Enter function code 20 then press #, the display will show
Step 3
Enter 1-9 then press #.
Step 4
Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
21
RELAY 2 (DOOR 2) REMOTE ACCESS
NUMBER SELECTION
(Default setting is 8)
Remote access number is used for all tenants to
provide remote access to their visitor(s). This
number can be changed. The AeGIS 8000
Series have two relay, the first relay remote
access number is set for number 9. If you
change the remote access programming on
relay 2 to a different number, do not select
number 9, if you do so, the second relay cannot
be released using the 9.
Step 1
Log on to programming mode, see instruction above. The display
will show
Step 2
Enter function code 21 then press #, the display will show
Step 3
Enter 1-9 then press #.
Step 4
Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
40
MASTER CODE MASK
(Default setting is 0 for UNMASK)
MASK:
Master code cannot be retrieved using
the master code retrieve button. If you
forget the master code, you must
purchase a new memory chip.
UNMASK: Master code can be retrieved using
the master code retrieve button.
Step 1
Log on to programming mode, see instruction above. The display
will show
Step 2
Enter function code 40 then press #, the display will show
Step 3
Enter
• 1 = MASK
• 0 = UNMASK
then press #
Step 4
Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
46
VERIFY MODEL AND FIRMWARE VERSION
Step 1
Log on to programming mode, see instruction above. The display
will show
Step 2
Enter function code 46 then press #, the display will show
Select Func: _ _
OpenDoor1 No: 9
Select Func: _ _
OpenDoor2 No: 8
Select Func: _ _
MC_MASK 1=YES: 0
Select Func: _ _
V :XXXXA MM/DD/YY