Pach and Company AeGIS 7000 Series Manual - Manual (Page 14)

Chapter 3
PROGRAMMING
The AeGIS 7000 Series can be programmed locally using the built-in keypad or remotely via a touch tone phone.
3.1 LOCAL PROGRAMMING VIA BUILT-IN KEYPAD
Log on to programming mode
Two ways to log on to programming mode:
1) PRESS 0 AND # SIMULTANEOUSLY THEN RELEASE , the display screen stops scrolling (If the display screen is still
scrolling repeat this step again) then enter the valid 4-digit Master Code (default Master Code: 0000). Now, you are in
programming mode, the display shows:
and proceed to Local Programming Table 3.1. If the system idles in 30 seconds, the display will return to a scrolling mode.
2) IF YOU DO NOT HAVE A VALID MASTER CODE , open the panel (key must be used) then press and release the “RED
BUTTON” on the board and the display shows:
x x x x: 4-digit Master Code.
then press #. Now, you are in programming mode and proceed to Local Programming Table 3.1. If the system idles in 30
seconds, the display will return to a scrolling mode.
3.2 REMOTE PROGRAMMING VIA A TOUCH TONE PHONE
You may use Telephone Remote programming to add a tenant, delete or modify the system's parameter. The rules below
must be followed:
• Enable the system Auto Answer (see table 3.1 Function Code 74-Enable or Disable Auto Answer), the AeGIS
7000 Series will answer on the first ring.
• Do not share the AeGIS 7000 phone line with any answering devices such as a fax machine, alarm device or
modem.
• A touch-tone phone must be used.
• Only letter A-Z can be entered using a touch-tone phone for a person name. No punctuation or number can be
entered.
• A person name only in upper case.
Log on to programming mode
1) SINGLE SYSTEM
Step 1 Call the AeGIS 7000. When the system answer you will hear:
One Short Beep: Door is opened.
Two Short Beeps: Door is closed.
Press # key
Step 2 Press your valid Master Code.
• If your Master Code is accepted, you will hear Two Short Beeps and now, you are in the programming
mode and proceed to Touch Tone Programming Table 3.1.
Note: If the system idles in 30 seconds, the display will return to a scrolling mode.
• If your Master Code is rejected, the system will disconnect.
Pach and Company Chapter 3 Page 7
AeGIS 7000 Series PROGRAMMING
Select Func: _ _
Master Code: x x x x